POOL IONIZER ELECTRODES, REPLACEMENT ANODES, CATHODES

Description

US BUYERS ONLY
INTERNATIONAL
CUSTOMERS SEARCH “PRICE-LESS PRODUCTS”
HEAVY WEIGHT REPLACEMENT IONIZER ( IONISER ) ELECTRODES FOR MOST POOL AND SPA IONIZERS WITH 2″ MALE PIPE THREAD PLUG.
THEY HAVE 2 STAINLESS (NON CORRODING) POSTS WITH STAINLESS STEEL NUTS.
THESE ARE PURE COPPER ELECTRODES (99.9% PURE), NO FILLERS, LIKE CHEAP ZINC WHICH IS 8 TIMES CHEAPER THAN COPPER AND HAS NO PROVEN DOCUMENTATION  TO BE EFFECTIVE IN POOL IONIZATION.
NOT ONLY THAT, COPPER IS THE ACTIVE INGREDIENT LISTED BY ALMOST ALL IONIZER MANUFACTURERS FOR EPA CERTIFICATION AND LICENSING.
THESE ELECTRODES WILL FIT THE FOLLOWING IONIZERS BY CUTTING THE WIRE BY THE OLD ELECTRODES, STRIPPING BACK THE INSULATION AND WRAPPING EACH WIRE ON EACH POST AND TIGHTENING IT BETWEEN THE NUT.
PRICE-LESS PRODUCTS
CLR-POOL-1 CLR-POOL-2 (CPI-1, CPI-2)
AWESOME / SUNSHINE POOL PRODUCTS: SPE PC-E, SPS
ALMOST HEAVEN / PROMOLIFE.
MODEL: POOL STANDARD IONIZER (PI-S) PIS
IT WILL FIT THE FOLLOWING WITH NO MODIFICATION:
PIONEER MINERAL PURIFIER
P-15
THE ADVANTAGE TO THIS CONFIGURATION:
YOU NEVER NEED TO TAKE THE CONTROL COVER OFF OF YOUR IONIZER AND RISK SHOCK, OR RUINING THE CIRCUIT BOARD.
THE THREADED POSTS KEEP THE ELECTRODES FROM DISLODGING IF THE POTTING MATERIAL GIVES OUT, WHICH HAS HAPPENED ON THE TYPE THAT JUST HAVE WIRES DRILLED THROUGH THE TOP AND POTTED WITH RUBBER.
PRICE-LESSPRODUCTS MODEL CPI-2 OPTION 2
DISCLAIMER:
1.
1
.
Ionizer electrodes are to be used with a
swimming pool Ionizer system or a Spa ionizer system.
Not
a homemade power source.
2.
2.
ELECTRODES
ARE WEAR ITEMS.
That is, they are
supposed to wear out
as you
supply electricity to them.
This is how
the sanitizer and algaecide are disbursed into the pool/spa.
3.
3.
Once the electrodes are in your
possession,
I cannot control what you
do to them.
IT IS POSSIBLE TO
DISSOLVE A FULL SET OF ELECTRODES COMPLETELY IN A VERY SHORT TIME IF YOU DO NOT
MONITOR AND TEST THE COPPER AND CONTROL THE POWER SUPPLY THAT IS POWERING YOUR
ELECTRODES.
We recommend that you
maintain 0.3ppm of copper in your water and should check it weekly and adjust
your controller settings accordingly. If your ionizer manufacturer recommends a
different level, follow their directions. That way you will get maximum
electrode life and optimum sanitation.
ONCE INSTALLED, WE DO NOT WARRANT
THE ELECTRODES FROM WEARING OUT, THEY ARE SUPPOSED TO DO THAT.
Thank you,
Greg Price
Price-less Products